Brief Introduction

This is a pill-shaped cable winder processed with materials and cutting tools from the Z1 basic accessory kit. It features practical functionality and a clean design. It is ideal for beginners to get familiar with part machining and assembly. Besides stock materials from the kit, you will also need 2 pins from Z1 tool box for assembly.

Processing Steps

Stick the ABS sheet to the bed along the fence at Anchor 1.
Upload the toolpath WC_F3.175T1E0.3T2_1.nc, install the tool 1, start machining.
Change the tool following the instruction, then continue machining.
After the machining is done, take the parts out.
Secure the epoxy tooling board to the bed with M5 screws and clamps at Anchor 1.

Upload the toolpath WC_F3.175T1_2.nc, install the tool 1, start machining.
After the machining is done, take the parts out.