Workholding demonstration during machining

1、Controller Parameter Settings Before Machining

1. Install the cutting tools into the corresponding tool magazine in advance. For equipment without a tool magazine, prepare the tools in advance and replace them when prompted by the system;

2. Upload and select the NC program

3. Configure the work coordinate system: relative to anchor point 1, X offset 0, Y offset 0;

4. Check the "Scan Border" option;

5. Check the "Auto Z-axis Tool Setting" option, set the tool setting point relative to the path origin: X offset 65, Y offset 45;

6. Uncheck "Auto Leveling". (Since the material surface is very flat, automatic leveling detection is not required);

7. Close the equipment protective cover and run the program.

Notes:
1. If problems occur during machining, press the emergency stop and return to zero. For resuming machining, uncheck scan and Z-axis tool setting, then run directly.
2. The model size can be adjusted as needed, but please note that the Z-axis direction must not exceed the blank material thickness after adjustment.

2、Machining Process Stage Photos

Roughing stage: The tool is performing contour roughing, gradually removing excess material

Finishing completed: The overall contour of the panda relief is clearly presented with rich details

3、Post-processing

Use a soft brush to clean debris from the surface

Use a soft bristle brush to carefully clean wood chips and debris from the relief surface and gaps. Pay attention to brushing gently along the texture direction to avoid damaging the relief details.

Finished product effect: Panda relief finished product display

Finished product display: The panda has an adorable facial expression with delicate and natural fur texture. The surrounding bamboo branches and leaves have distinct layers.

熊猫救济

熊猫救济

项目介绍

使用说明

表面处理

评论